News Center

Factors for blockage of oil press:

　　1. The sieve cloth oil is taken one side. During inspection, if the screen surface is not horizontal, the length of the left and right booms should be adjusted to make them equal; if the screen body is twisted, the eccentric wheel shaft can be adjusted to make it vertical to the frame. If the oil on the screen surface is removed from the stone, the frame can be adjusted to make it level; if the air flow is uneven, the air box of the air box can be adjusted to make the air flow evenly blow to the screen surface. If the sieving rate is low, the brush should be replaced or the length of the brush should be adjusted, and the inclination angle of the flat screen should be adjusted at the same time.

　　2. the belt lubrication does not lift the material. The main reason is that too much oil accumulates in the lower part of the conveyor of the bucket elevator, causing blockage. You can open the plate door at the lower part of the conveyor to remove the accumulated oil.

　　3. The steamed dough is uneven on the pot. During inspection, if the steam injection hole of the steamer is blocked or rusted, the steam injection hole should be cleared. If the blank is pasting the bottom of the pot in the middle and lower pot, the distance between the scraper and the bottom of the pot can be adjusted; if the scraper is twisted and worn, the scraper should be replaced; if the blank is unevenly cooked, adjust the limit switch, Contacts and floating plates to coordinate their movements.

　　4. The roll does not rotate when overloaded. The elimination method is: if there is oil between the rollers when the small oil press is started, loosen the roller adjusting bolts to remove the oil between the rollers; if the feed rate is too large and the speed is too fast, you can close the insert plate at the discharge port ; If the thickness of the rolled blank is uneven, the roll gap should be readjusted and the loose nut should be tightened.